1
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PDMX-122 CONTROL VOLTAGE
« on: January 18, 2024, 07:19:31 PM »
NOW IT SEEMS TO BE WORKING ROPERLY
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PDMX-122 CONTROL VOLTAGE
« on: January 18, 2024, 07:18:14 PM »
I have a PDMX- 122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
WHAT IS WRONG WITH THIS FORUM?
I checked the voltages for the direction pins on the XYZ axis And they each registered 3.4 V and 0.2V when checking the direction pens.
Does this voltage sound acceptable, or is this what is causing my problems ?
Thanks
Chuck
WHAT IS WRONG WITH THIS FORUM?
I checked the voltages for the direction pins on the XYZ axis And they each registered 3.4 V and 0.2V when checking the direction pens.
Does this voltage sound acceptable, or is this what is causing my problems ?
Thanks
Chuck
3
Parallel Port breakout boards, motherboards, and dedicated accessories / PDMX-122 CONTROL VOLTAGE
« on: January 18, 2024, 07:16:32 PM »
I have a PDMX-122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
It
It
4
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Acceptable voltage PMDX
« on: January 18, 2024, 06:04:57 PM »
Why can
5
Parallel Port breakout boards, motherboards, and dedicated accessories / Acceptable voltage PMDX
« on: January 18, 2024, 06:03:10 PM »
My milling machine quit working, and I
6
Parallel Port breakout boards, motherboards, and dedicated accessories / PMDX-122 issues
« on: January 18, 2024, 11:46:46 AM »
I have a PDMX
7
Parallel Port breakout boards, motherboards, and dedicated accessories / PMDX-122 issue
« on: January 18, 2024, 11:36:36 AM »
I have a PDMX- 122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
It
It
8
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PDMX
« on: January 18, 2024, 02:07:33 AM »
For some reason, all of my messages did not come through so let
9
Parallel Port breakout boards, motherboards, and dedicated accessories / PDMX
« on: January 18, 2024, 02:04:34 AM »
I have a PDMX- 122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
It
It
Pages: [1]