Messages

1

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PMDX-126 & UC400ETH Compatibility

« on: December 14, 2016, 02:24:35 PM »

So it has been a few months. I just wanted to check to see how you are doing with the UC400ETH and PMDX-126 and the UCCNC Software. I am doing some Servo upgrades and figured I might do a software upgrade at the same time. I essentially have the same hardware you mentioned in your first post and was wondering if you have experienced any incompatibilities with the spindle controller card.

2

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PMDX-126 & UC400ETH Compatibility

« on: July 06, 2016, 07:35:48 AM »

I got my UC400ETH installed, and it works very nicely with the PMDX-126 and other hardware in my system. Installation was very easy, and I didn't have to do any reconfiguring of things other than deleting the Ethernet SmoothStepper plugin, and installing the UC400ETH plugin. Mach3 works exactly as it did before, and I'm going to be putting UCCNC through its paces soon.

So the UC400ETH is essentially a drop in replacement for the ESS?

If so that is great news.