M62P1/M63P1 on PMDX416

[Rubes]

Does the PMDX416 support the M62Px/M62Px commands in Mach4? from what I gather these used to be M10Px and M11Px
I am trying to turn a laser on/off and understand this is a faster/better way to do it to not get the "bloom" at the start of a line.

found this old thread that used macros to enable an output with M10
https://www.pmdx.com/PMDX-Forums/index.php?topic=217.msg826#msg826
wouldnt running a macro be slower than just using M3/M5?

Im useing:
SmartBOB Plugin version: 0.53.263
SmartBOB firmware version: 0.60.208
SmartBOB bootloader version: 1.13.73

Thanx

[12strings]

If you look in the plug-in release notes, it says M62/63 have been supported since version 0.38 (2016).